Has anybody managed to integrate the LCD Statuses to feed back into the user interfaceI'm still playing around with the integration between my Texecom Alarm and Loxone kit and still have not managed to find the 'seperator' value to send multiple commands to the texecom RS232 interface. Has anybody managed to integrate the LCD Statuses to feed back into the user interfaceĤ. I've tried sending the following using various separators without any success KEY1, KEY2, KEY3, KEY4, KEY5, KEY6, KEYA, KEY2, KEYYĤ. Is there a way to use some form of separator to send multiple commands to the texecom RS232 interface, so that I could for example create one actuator to send the following (6 digit user number, arm area B as a string. The actuator outputs can only be used once, therefore can anybody recommend a way to achieve sending the relevant Actuator responses without requiring 9 to 10 memory flags per area.ģ. I have 4 area's on my panel which need to be armed / disarmed individually (and/or collectively).Ģ. If i enter the 6 digit number from the Loxone by pressing the relevant push buttons, then I can arm and disarm the Texecom panel using the Loxone App, but it's far from a seamless end user experience.ġ. I created push buttons for each of the KEY0 to KEY9 actuators along with KEYA, KEYY etc. Update on my original post - I've managed to send individual KEYx commands to the Texecom Panel. Has anybody managed to achieve this? and if so, would you be willing to share how you set this up in Loxone Config?

I have managed to send commands such as LSTATUS and ASTATUS to get the LCD and Area statuses back from the alarm panel so I know that 2 way communication is working OK, but I can't send the arming codes and get the system to remote arm. However, a few users say that they have managed to get communications working the other way, however I haven't seen anybody share how they have achieved this.Īpparently it is possible to send RS232 commands from the Loxone Panel to Arm and Disarm the Texecom panel by sending the 6 digit user code along with Y for full system arming, however I can't get this to work. This enables me to use the Loxone system to trigger Cloud dialler for alarm activations, use PIR's to trigger lighting etc, which is all working well. in casecontrol panels of KC patients without known family history. I have the Texecom PC Com module connected to the Loxone RS232 module and I'm able to receive outputs from the alarm panel into the Loxone system (Arming, Disaming, Zone Status, etc.) GENES FOR FAMILIAL KC LOX One of the first discovered and most promising KC genes is.

Loxone panel